Mercedes Increase Speed Limit by Autel MaxiSys Pro MS908P

How to reprogram Mercedes Benz C240 to remove the speed governor that is set at 250k/h (from original 130 km/h).
Requirement:
Autel MaxiSys Pro MS908P
Autel J2534 MaxiFlash Pro ECU Programming Tool
Steps:
Connect MS908P and J2534 with Benz C240.
Go to “MaxiSys-> Diagnostics-> Benz-> vehicle detect”.

Gateway data initializing…
Get the VIN number. Tap OK to go on.

Autel Maxisys Pro MS908P Automotive Diagnostic Scanner Tool With ECU coding and J2534 Reprogramming

Select the date of manufacture vehicle. This case is up to 2003.
Press the button left to select left-hand steering.
System data initializing…
Communication is established…
Go to Programming/Coding.

Autel Maxisys Pro Ms908p, Wholesale Various High Quality Autel Maxisys Pro Ms908p Products
Go to ME2-SFI-Motor electronics 2.

Autel Maxisys Pro MS908p Scanner Full Review
Establishing communication…
Go to Variant coding.
Go to Display of coding data.
Go to Coding.
System data initializing…
Scroll to 2031 about speed limit. Put on the bar.

Buy Autel Maxisys Pro MS908P Automotive Diagnostic Scanner
Tap F2 Edit.
Set 250 km/h, and tap OK.

Tap F3 send.
Tap OK to make sure that the coding is transferred to the control unit.
The coding has been carried out.
Turn off the key and then turn the car back on. Then you can go for a drive.
Ps. cool thing!!
Go to instrument cluster.
Establishing communication…
Go to Active Test.
Go to Actuation of the instrument pointer up to the maximum position. And you will see

Find More Car Diagnostic Cables & Connectors Information about 100% Original AUTEL MaxiSys Pro MS908P Car Diagnostic
============================
E-mail:Sales@obd2tool.com
Whatsapp:86-18003909206

Upgrade Process for K518 Adaptor Kernel

After the APK of Lonsdor K518 is upgraded to V1.6.0 version, the adaptor requires to be installed new kernel beforehand. Please refer to below operations.
Step 1: Connect the device to the specified adaptor and plug in 12V power, as shown below.

Step 2 : Start up the device, and input password to enter home screen. Click “Update firmware” button in below red box.

Step 3: The following interface appears, click “Install Adaptor” in below red box.

Step 4: It skips to the below interface, click “OK” to continue.

Step 5: It skips to below interface. You will see the progress indicator moving rightwards. When downloading is completed, click OK” and exit. The adaptor kernel is installed successfully.

How to use BMW 35080 adapter with Yanhua Mini ACDP

I have a question about Yanhua Mini ACDP + module 4 BMW 35080 read and write: Can the 35080 adapter be used with puncture socket so don’t need to remove eeprom?

Obd2tool.com engineer answers:
The BMW 35080 adapter has to be dismantled to read and write with Yanhua Mini ACDP, instead of using with Puncture socket.
Please desolder the chip like the following image shows:

OK, so one more question is what is this seat used for?
Answer: It is reserved, not used yet.