Piece of content make suggestions the best way to install VAGCOM 12.12 on Windows and VCDS software.
CAUTION:
There's several version of VAG-COM 12.12 online. Unfortunately 99% of them are using low-grade hardware chip with additional of cracked VCDS software (sometimes needed an awkward 2013 date adjustment). In the event you own this type of version, beware half of functions will not work. Consequently we recommend you receive the total VAG-COM 2015 cable with original, unlocked and full version of VCDS software from Ross-Tech™ — by clicking here.
Step # 1: Install Ross-Tech VCDS Software
DO NOT plug VAG-COM cable into computer yet. Also don't launch software after install.
First install VCDS 12.12 software that had the package.
Leave original installation path of: C:\Ross-Tech\VCDS
Step two: Plug VAG-COM 12.12 Cable Into Computer
Plug VAGCOM cable into any USB port on your pc.
Allow about 2-4 minutes for Windows to automatically install drivers.
VAGCOM If Windows says that drivers are successfully installed, then can skip to Step . 4.
VAG-COM 12.12 USB If Windows doesn't install drivers, then carry on and Action 3 below.
3: Install Driver Files
1) Check out Control Panel.
Windows Vista/7/8/10: User interface » System » Device Manager
Windows XP: Control board » System » "Hardware" tab » Device Manager
2) Expand "Ports (COM & LPT)".
3) Right-visit "Ross-Tech" » Update Driver Software.
4) Choose "Browse Computer for Driver Software".
vag-com-ross-tech-driver-installation-windows
5) Browse to: "C:\Ross-Tech\VCDS". Therefore it need to look similar to this...
vag-com-ross-tech-driver-installation-windows
6) Click "Next". When you buy below message, choose "Install this driver software anyway".
vag-com-ross-tech-driver-installation-windows
That's all. Cable has become installed. Attend Step four below...
Step # 4: Disable Internet & Launch Software
Before launching the software...
You should disconnect from online/WIFI before launching software. For anyone who is linked with internet - then VAGCOM cable will never be detected by VCDS software.
Launch software from Start Menu. Or from C:\Ross-Tech\VCDS\VCDS.exe
Check out: Options » Test (get forced out as USB)
It ought to show "Interface Found", as seen below...
vagcom-ross-tech-driver-installation-windows
Click "Save". You're now ready to scan your vehicle.
